ELFCAM
Description
Highly flexible G.657.B3 single-mode fibre cable with a pulling eye to draw it through a wall, trunking or a duct without damaging the fibre. Once through, the SC/APC connector is reassembled by hand, with no tools — 50 m, 100 m or 150 m.
The single-mode fibre most tolerant of tight bends.
You pull on the metal ring, not on the fibre.
The connector housing goes back on after the pass-through.
Thin cable that fits narrow trunking and ducts.
Halogen-free, low smoke, tensile resistant.
50 m · 100 m · 150 m.
Made to be pulled
The built-in pulling eye lets you draw the cable through a wall, trunking or a conduit. On the other side, the SC/APC connector goes back together with no special tools.
Six steps from start to finish
Slide the metal tip into the protective sleeve, pull, remove the eye, then reassemble the SC connector by clicking its housing on.
The fibre never takes the strain
The pulling force goes through the stainless steel ring, not the fibre: it does not break, even in a tight bend. Hook it to a fish tape to bring it up to the box.
G.657.B3 fibre
The G.657.B3 standard allows very tight bends with little loss: the cable follows the corners of trunking and skirting, ideal for FTTH at home or in the office.
G.657.B3 SC/APC single-mode cable Ø 3.0 mm, LSZH jacket, pulling eye, tool-free reassembled connector, compatible with Orange, SFR and Bouygues routers. 50 m, 100 m or 150 m.
Highly recommended. My internet speed is now at its maximum potential. Exceeded my expectations.